Carbon Fiber Protective Case for Decased HERO 6/7 (w/ GoPro BEC!)
This case is packed with the BEC board, made for GoPro Lite camera. If you already have has a GoPro HERO 6/7, this is the best choice to make your naked GoPro to be super neat and light. Meanwhile, it can protect your GoPro motherboard well in a heavy crash.
This case and BEC board fit for GoPro Hero 6 and Hero 7 Black. But NOT for Hero 8.
- BEC Board is specially designed for Naked GoPro Hero which weighs about 1.5g, make your naked GoPro lighter and easier to install on your drone.
- The BEC output voltage is 5V@2A, avoid the accident of power off which is caused by the insufficient power supply for the FC board.
- Integrated GoPro stock buttons, Power/Mode Button and Record Button.
- Integrated GoPro stock LED to know the status of the camera.
- Pad is available for pilot to control the GoPro recording via the radio transmitter.
- With the pluggable connector, which is easier to connect with your flight controller for power supply and recording.
- Item: Case for GoPro Lite Camera
- Output: 5V@2A
- Voltage: 2-4S
- Connector: GH 1.25 3P Connector
How to Assemble
- Step 1: Assemble the BEC board on the GoPro motherboard and put the shim 1 and shim 2 to fill small gaps between them.
- Step 2: Hold the camera lens and the camera board at the same time, be careful when you assemble the board on the case.
- Step 3: Screw the GoPro motherboard with the M1.4*5 screws as shown below
- Step 4: Install the carbon fiber board, and screw the board with M1.4*8 screws as shown below.
- Step 5: Install the camera lens holder as shown below and screw the camera lens with M1.4*12 screws.
- Step 6: Install the ND filter holder and camera board holder to make it done.
ND Filter Holder
This ND Filter Holder fits perfectly for the standard GoPro ND filter (Not including).
- 1 * BEC Board for GoPro Hero
- 1 * Case for GoPro Lite Camera
- 1 * GH1.25 Power Cable (80mm 30AWG)
- 2 * Shims to fill small gaps
- 1 * Pack of Screws